I am setting up a new Eggbot but I am seeing a "Failed to connect to EggBot. :(" error whenever I try to apply anything in the Inkscape Eggbot Controller. I am able to see the Eggbot controller board in my windows device drivers and control panel on COM 5 when I plug it in. I have seen posts about "Unable to find an Eggbot on any serial port. :(" and did see that error, but I have corrected that issue and now am seeing the failed to connect error. Can anyone offer any advise on a next step to try.
I am using Windows 8
Eggbot Software: Version 2.7.1
Inkscape 0.91
Power Led is solid Green and USB LED is flashing Green
Thank you.